Tub Bearing Washer

Watched the Video took parts off one by one got as far as the nut there there had a problem with it had to soak it in W D 40 then was able to get it off needed to buy a new Nut split ring broke when i took it off but i have ordered the parts a head of time all of the main parts were rusted bearings ,hub washer,so it was a good thing i go ... Read more t all of the main parts the belt was starting to show wear. got a new one but as for the loud noise I found that the Transmission bearing went bad so ill have to get a new one. The job was not all that hard the nut was the main problem the seal was a bit hard to get off so i the whole tub out of the Machine had it upside down and put a screw driver thru hole and pop it out that way the tub bearing was the same way flip tub over a pop it out from the front when seal was out found it works better that way then the way it shows in the Video put a little liquid of soap around edge of seal it goes on much better Hope all this helps you out

I used youtube to figure out what i needed. After trying to get the large backwards threaded nut off with my rachet, i ended up taking it to my buddys house and using his impact gun. It was a breeze after i was able to get the nut off. While it was all apart, i cleaned all the old detergant off that was built up under the agrator.

Follow the videos. They explain how to do this repair extremely well. Don't forget that the nut that holds the basket is a left-hand thread. I used a pipe wrench and a hammer to break it loose. I used a screwdriver to stab the old seal and pry it out without damaging the tub. It came out pretty easily. I used hand soap to lubricate ... Read more the new seal and fit it in after cleaning out the tub's seal seat. It's a relatively easy job and now it doesn't leak and the noise is greatly reduced. I also lubricated the bearings with Lithium grease but that required taking the entire machine apart which is also explained in another video......

New shaft, belt and housing. Installation was going fine until went to install belt and IT was way to short .THANKS