Rear Drum Bearing

Remove 4 screws inside door and swing top back(hinges). Remove front by taking out screws(2) inside top corners and loosen screws(2) at bottom of panel. Swing panel to side of dryer; no need to disconnect any wires. Remove access panel on back of dryer and take off spring clip and washers from end of drum shaft. Pull drum forward abou ... Read more t 6 inches(can do this without removing belt) remove old bearing and install new. Reinstall drum. Front slides are a simple remove and replace; helps to have something to hold drum up an inch or 2. Reassemble in reverse order

The belt had broken on the dryer and I had purchased a replacement locally. What I found after dissembling the dryer was the drum slides, idler pulley wheel and rear drum bearing were very worn and needed replaced. Each were very easy to remove and replace. Slight challenges were lining up the pulley, reseating the drum with the belt a ... Read more nd solving the how the two (belt and pulley) were configured. It did require a second person. Note: Do not drop any parts into the dryer when reassembling. It will require you to start all over.

Removed the 2 screws at top of open door to access top cover removal. Removed 2 screws at top of front face panel and took front off. Removed dryer tub , replaced bushing and the replaces sliders on front panel.Very easy