Rear Drum Bearing Kit

New shaft, belt and housing. Installation was going fine until went to install belt and IT was way to short .THANKS

I followed the you-tube directions. The only problem I encountered was reinstalling the drive belt on the motor and pulley. Directions recommended that you seat the drum in place and reach back to the pulley and seat the belt by feel. I had no luck so I pulled the drum forward where I could see the motor and pulley then I seated the bel ... Read more t and carefully pushed the drum back pulling the drive belt forward as I went until the drum was all the way back and seated.

Kit labeled Genuine GE and the brackets and bearing were fine - better bearing material than original. Problem was the bracket mounting holes were punched and designed for "self-tapping" screws. Not what was supplied. Supplied screws had no tapered thread at tip and no chip-cutting relief to do the cutting. Impossible to properly star ... Read more t the screws in the punched holes. Luckily, I saved the 19 yr old screws which were proper "self-tapping" design. Chucked bracket in vise - precut threads and then installed in drum. Otherwise easy repair and wife's happy with her dryer again.

Repair went well but the dryer still squeeks for a couple of minute when it is turned on. Watched UTube.

Took top& 1side off, belt ,removed old parts replaced with new ones (gas dryer) needed two people to tilt back to remove bottom screws !relatively EASY.

As described in the video posted at your website. I like to commend the technician in the video. He did a excellent job in explaining how to take apart, replace the item and put it all back together. .

Unplug machine. Removed screws in top of door that holds top on. Tilt top back. Remove 2 screws on side that holds front panel on. Slide panel to side.In rear of machine remove access panel to remove belt. Remove one screw to access hole to drum bearing. Remove drum by picking up belt to lift drum. Lift drum out. Remove 3 screws that hold ... Read more s bearing stud on install new stud. Remove 4 screws that hold on bearing. Install new bearing. Use a spot of wheel bearing grease, install drum, install belt. Install rear panels. Install front and top. Test

I just watched the video on how to repair, and went step by step. The only problem was putting the belt back on after re-installing the drum. I made a hook out of a hummingbird feeder wire and reached in to hook the idler wheel arm, using my right hand, then using left hand set the belt back on motor pulley and on the idler wheel. This si ... Read more te has very good service parts were shipped on time, and all fit perfect.

Went on to your website and watched the video followed instructions word for word went great never worked on a dryer before this.

Searched Internet for dryer model squeeking. Found probable cusses. Watched video. Took dryer apart found the above parts worn out. Changed the belt and idler pulley just because I had the dryer apart. Less than 50 minutes dryer is fixed. Dryer is like news for $133.00