Door Switch Kit

removed screws holding top panel in place. Disconnected 2 wires from switch and pressed expansion clips in and pushed switch out front of panel. pressed new switch into place, connected terminals, placed panel back in place replaced screws, tested dryer and done.

Take time to examine your machine before ordering parts, I did not need to expensive roller wheel kits , I needed two washers for the roller wheels. I pulled it apart and used the snap ring pliers to pull the roller wheels off,put the washer behind the wheel , I added a dab of hi temp grease to inside of roller and shaft. Put it back to ... Read more gether. Quite as a new one. . The rest of the parts are straight forward . . Good luck

I popped the top of the dryer off by sticking a flathead screwdriver in where the clamps hold it in place, then I used a socket wrench to unscrew the door. I couldn't figure out how to get the switch off without taking it apart (should have left it connected, would have saved me some trouble). I took a picture of where the wires were conn ... Read more ected. When I got the new switch, I removed the nodes from the wires by using an eyeglasses screwdriver to release the clip holding it in place under the plastic. One of the wires' covers was too small to fit on the new switch, so I stripped the wire carefully and replaced the end with the one provided. The fit wasn't very good, so I'll probably have to put some electrical tape on it at some point. Then I reattached everything and voila, dryer turns on :)

Having repaired it before, I knew what it needed. ordered all new rollers and because of age a new drive belt. Needed a new door switch, had bypassed it a while ago. finding the parts on the site was a snap, great setup. FIRST, DISCONNECT THE PO ... Read more WER!!! VERY EASY FIX. Lean the unit against the wall at about 30-40 degrees and start removing the screws from the bottom and lift each panel off by pivoting. Take care when removing door frame, unplug the wires. Remove drive belt before removing the drum. Check roller shafts for excessive wear or just replace them with the rollers. make sure you put the spacer back behind the rollers and the rollers facing the right way. Use caution with the felt drum sealers when replacing the drum and the door frame. CLEAN OUT THE LINT BUILDUP WHILE YOU HAVE IT APART. VAC THE MOTOR CLEAN TO PREVENT OVERHEATING.