Door Gasket

door seal didn't have white stripe as mentioned in the repair video but it looked ok after install. i ran a cycle and stiil had the leak. Ok so i removed the seal and cleaned up the cabinet, installed seal again. STILL Leaking but not as much! Now what? I adjusted the front leveling nuts/legs to lift up the front of the dishwa ... Read more sher a little and ran another wash cycle. No leak this time. Total repair time should be adjusted for the 24hr waiting time so adhesive can dry after 2 installs and about 2 hours for running thru the wash cycles.

Pulled the old one out very easily, it wasn't glued in. Made sure the groove was clean. Installed the new one with no glue that came with the new seal and ran the dishwasher for full cycle and no leaks.

Took oput the old and put in the new.5 minutes tops. No more leaks!

Easily removed the old seal, completely dried the seal channel. Applied the glue per instructions 1/8 inch and inserted the new seal again per instructions (very clear). Closed door for 24 hrs to let glue dry. Ran dishwasher with no leaks from door. Factory part was exactly as described. A+ rating.

followed the video instructions and changed the door seal gasket. now it does not leak. :)

I opted to reinsert the old gasket, which was not cracked or hardened, once I applied the bead of adhesive in the track around the frame. I'm keeping the new one as a backup in case this fails. So far no problem but I'll know better in six months or so.

The float switch is located on the lower right underside of the washer. You need to remove the cover plate. It helps to remove the door panel also so you can get better access. The white housing that contains the switch, the switch lever and the float stem is all in the unit. A tube that houses the float stem extends up into the washe ... Read more r tub. There you find a plastic nut that secures the unit. Unscrew the nut and the unit will drop down under the washer. the unit snaps open from right to left. The first time I was working with the old one I broke it trying to open it. Make sure you attempt to open it by releasing the right side of the housing. Oncde you get it down and open you can remove the switch and the wires. Take some pictures with your phone so you can see how it reassembles when you put the new one in. Not a hard repair but as I said I had to break tho old one to learn how to install the new one.