Dishwasher Door Gasket - Gray

It was real easy to change the door seal after I watch the repair video.Only after i installed the new seal it leaked worse than before.After reading up on the problem iI decided to check the float it had crud in it and the Vent in the door was full of crud and build up. After cleaning them and freeing them up. The dishwasher works great ... Read more . the seam and water have to have some where to go when the machine is running., if the float is plugged the washer will over fill. and if the vent in the upper door is plugged the water will be pushed out the bottom of the door and because the door had a new seal it made more water come through the bottom of the door because it had a tighter seal. hope this helps some one. this saved me from buying a new machine.

Replaced the door seal by noticing the way the old one fit, pulling it out of it's slot,finding the center of the new seal, push it in the groove starting at the center of the machine and work your way to both ends making sure it is seated well all the way around.

I used a flat screwdriver to loosen the old gasket at the bottom end. Once I loosened it I pulled it off. I lined up the dot on the new gasket with the top middle slot and pressed it in. Then I placed the gasket along the slot and pressed it in with my finger first working from the middle and to the right and did the same on the left side ... Read more as shown on your video. I ran my finger over it 3 times before starting the dishwasher. This did not stop all of the leak. As another costumer mentioned I then removed the vent cover from the inside of the door. It was packed with mineral deposits. I cleaned this out and replaced the vent cover. I restarted the dishwasher and had a few drips for about 20 minutes, then they stopped. I have successfully ran 2 loads of dishes since without any drips or floods.

I took off the old seal, cleaned around the door, and put the new gasket in the dishwasher.

Removed the old door gasket, replaced it with the new.

I removes original gasket and cleaned the channel then, followed the video instructions provided with the order. The instructions were complete and accurate. My dishwasher is back together and working like new. I am one "happy lady".

Using pliers removed the existing gasket, then aligned the green dot on the new gasket with the top center of the dishwasher. Then gently placed the new gasket in the groove where the old one was removed. The replacemed in under one minute.

Cleaned machine and replaced gasket work's like new

replace gasket. easy to do.....still leaks just a bit in the same place. Replacement was very easy to do. I wonder if there is another gasket needed between door bottom and kick plate.?

I cleaned the the air registers and where the gaskets sit. Then placed new ones in.