Touchpad and Control Panel - Stainless Steel

0. Remover power to the dishwasher but unplugging or turning off the circuit breaker. 1. Remover the 6 screws holding the Front panel to the door. 2. Remover the 4 screws holding the Control Panel to the top of the door. 3. Press the clip holding the cable from the control panel to the electronics module. 4. Replace the Control Panel with ... Read more the new one and screw in the 4 screws on the top of the door. Note these are the long screw that were removed. 5. Plug in the control cable to the electronics module from the control module. Replace the from panel, being careful to align the side correctly, It is helpful to have someone assist with holding the panel while inserting the first couple of screws along the sides. Insert all 6 screws (3 each side). 6. Check alignment of panel and door after tightening the screws. 7. Restore power