Seal

Note: this is a 2 drawer dishwasher. The front bezels/vents broke at the tab which locks in the module and compresses the seal. Remove the front panel starting with 2 screws on the bottom front. Pull front panel down to unlock and pull away. The next set of screws are fairly obvious, remove that layer of shielding. Not you can see th ... Read more e turbine looking vent module. There is one screw attaching it to the drawer, remove it, and disconnect 2 wires at the top. Now that module can be pulled away. Clean the sealing surface on the drawer and the module. Clean or replace the seal. Inspect the locking grooves to insure they are clear, the bezel tabs break off in those grooves. Reinstall module and lock in place with new bezel, move it around a bit to insure good seal. Reassemble in reverse. Note: there are 2 vents per drawer 4 total on machine, I would replace all 4 as they will most likely soon fail for the same reason.