Detergent and Rinse Dispenser with Cap

Step 1: Unplugged dishwasher.
Step 2: Opened dishwasher door and removed 8 Torx screws holding door front panel
Step 3: Removed front cover from dishwasher door and closed door.
Step 4: Removed screws from hold down ring around detergent dispenser.
Step 5: Removed wiring harness from detergent dispenser.
Step 6: ... Read more Opened dishwasher door and removed detergent dispenser unit.
Step 7: Cleaned area of door where dispenser was.
Step 8: Inserted new dispenser unit, replaced screws and tightened. Plugged wiring harness into dispenser.
Step 9: Replaced Dishwasher door, replaced screws and tightened.
Step 10: Tested door closure, plugged in dishwasher and ran dishwasher through a cleaning cycle.

I was a bit slow and was a bit not sure I could take this on . things went fine and It works great and my wife is happy so thanks. (by the way I am 86 ) jimbo

I had to use a 3 inch adjustable wrench and a tiny plyers to remove and re-attach the new unit. Very time consuming.

Replace dispenser unit. Requires taking the door apart to remove the existing unit. Turn off electric to dishwasher, open door by removing 10 screws around edge, Catch the now loose control module, disconnect the wire to the dispenser, take out the 6 screws holding it then spring the two clips to remove the unit. Now carefully replace ... Read more the unit with the new part, reconnect the wires check carefully that the new unit is centered in the hole and fastened well. (I left mine a little loose and had leaks that were difficult to solve.) Now carefully replace the control module and the 10 screws. reconnect the electric, test. and its complete.