Drive Belt

I first took the top of the dryer off by removing the 2 screws form the back of the dryer, and then I took the front of the dryer loose that holds the display this should be 4 screws, and carefully set it to the side be careful there are little clips on this piece that are plastic and will break if you put to much pressure on them. I then ... Read more found it easier to remove the door of the dryer you probably don't need to but it is the heaviest part of the front of the dryer and probably very expensive this is 2 screws. I than removed the screws from the lint filter and lifted up the front of the dryer and removed it. I than removed the lint collection cup? ( for lack of a better word I will use cup). At that time you can see the belt and the motor you take the drum out and get the belt around the drum this might take 2 people and make sure the belt is around the drum and the motor. Then you have to reach in the dryer and pull the tension arm up and hook the belt around it the belt should be taught but not extremely tight and than simply put the pieces back together as they came off. Make sure you roll the drum to see if everything is connected When putting the door back on make sure to not over tighten the screws. One other thing my dryer started making a clicking sound for a while before the belt broke I later found out that the belt had been torn a little and that was the clicking I heard. It tore from being used. This is not a hard job if you have a basic understanding of working on things and it was much cheaper than buying a new dryer. The staff at this site were awesome to work with and knew exactly what I needed.

Remove top of dryer,then remove the top front where the controls are ,then remove door ,then remove front panel of dryer ,and thats it install velt little by litte ,relace all pcs carefully and finish installation