Surface Ignitor

Remove the grates, knobs and burner caps. Remove the burner base using a T-20 torx bit. The cooktop can now be lifted and set to the side. Remove the draw in front of the cooktop and you'll see two black Phillips screws on each side that holds in the support bars that the gas tubes are attached to. Using an adjustable wrench, remove an ... Read more d set to the side all 4 gas supply tubes. Lift out the support bars and disconnect the wires that are connected to the igniters. Noting the position of the gas tube and location of the Phillips screw, remove the screw Next remove the Phillips screw that holds the igniter to the gas tube orifice and replace it with the new igniter. Reverse the process to reinstall and repeat the process to replace the other igniters. Make sure to double check the brass gas tubes nuts to make sure they are tight. The gas tube orifices can be moved around a bit to align with the burner base as they can be slightly misaligned after reassembly.