Spark Igniter Set

1) remove the cook top tray by lifting up on the back of it and gently pull it backwards 2) now that the cooktop tray unit is removed, remove two screws from each side and lift the drip pan off of the base tray 3) use pliers to gently pull down on the metal clip that holds the wire to the top burner igniter of both burners 4) remove t ... Read more wo screws that hold the igniter in place in gently remove it 5) place the new igniter in through the hole, and reattach the two screws that hold it in place. 6) I broke one of the wires and had to replace the spark igniter set ( wire harness). This was done easily by removing two screws replacing igniter set, then replacing the screws. 7) reattach the wires to the bottom metal prong of the top burner igniter. Do this for both burners. 8) gently set the drip tray back into the lower tray. Be careful to line up the tubing which will carry gas to the burner with the holes in the lower tray. 9) replace two screws on each side that hold the drip tray to the lower tray 10) gently replace the entire tray unit, being careful to first line up the metal prongs with the holes in the front of the unit. You should now be ready to cook again!

Remove the dual burner unit. Using phillips head screw driver, take the back cover off. Remove the old two prong connector. install the new two prong connector. Put the back cover back on. Install the dual burner into the stove top. Turn on burner to check.