This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.
Works with the following brands:
Amana, Maytag, Kenmore, Admiral
Works with the following products:
Refrigerator
Fixes the following symptoms:
Will Not Start, Freezer section too warm, Fridge too warm, Fridge and Freezer are too warm
Part# WP65889-4 replaces these:
AP6010187, 14202659, 14217273, 2252799, 2255130, 61002974
...
Show more, 61003525, 65889-4, 65889-5, 65889-8, 65922-1, 66121-1, 8170450, 8170462, C8931604, C8931608, C8931610, C8931612 Show less
Videos For installing this part.
Replacing your Run Capacitor
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched. Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Kay
January 10, 2022
having problem with freezer freezing up to much
For model number MSD2651HEB
Hello Kay, Thank you for the question. We suggest testing the Defrost Thermostat. The best way to do this is to remove the thermostat from the refrigerator so you can control the temperature of the sensor. You can let the sensor warm up to room temperature. With the sensor warmed up to room temperature the sensor should read approximately 6.2K Ohms at 68°F. With the thermistor submerged is a glass full of ice water, the sensor should be very close to 32°F which should read approximately 16.3K Ohms. If the values that you are getting are far off from these readings, then the sensor is bad and should be replaced. We hope this helps!
This includes both the run capacitor and the start relay. The capacitor helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.
The start relay boosts the com...
This part is both the start relay and the overload. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed and the overload provides extra protection against excessive temperatur...
Installation Instructions Provided by Fix customers like you.
Average Repair Rating: 4.3 / 5.0, 8 reviews.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
fridge and freezer were not cold - light was on and circulation fan was running
cleared storage items on top and along side of fridge; pulled out from wall; removed access cover and vacuumed all I could reach; these steps took 20 minutes, replacing the capacitor @ 10 minutes; troubleshooting guide indicated probable bad "run capacitor" located with "radiator" cooling fan and/or plugged into relay mounted on compres
... Read moresor. I located compressor option, only, and I replaced run capacitor. I could detect no cooling the first day, but 24 hours lated I had ice. It took another 24 hours for fridge section to chill my favorite beverage. I guess this makes for an energy efficient refrigerator, but it sure took a long time to cool, so give it time to work..
Disconect electric source and Outside back low removed the cover with my nutdriver and removed relay and capacitor and put the new ones on and replaced cover. Conceded and works fine.
Unplugged the Fridge. Removed screws holding cover to expose the compressor. Payed attention to where the white and black wire went. Removed wire clip holding the capacity and relay in place. Unplugged relay with capacitor attached. Assembled new run capacitor an relay. Plugged the assembly into the compressor. Inserted wire clip bac
... Read morek over the relay. Inserted the black an white wires into the relay. Plugged it in to check it. Started right up no clicking.
The part is located on the bottom of the back of the refrigerator side screwed onto the fan motor housing. It is difficult to get to because of the refrigerant lines. I jacked up the refrigerator side about 8" or so so that I could access the part from underneath as well. I then used a socket wrench along with an 18" extension with a joi
... Read morent on it. It was easily removed. As far as installing it I just held the screw and part in place from underneath and hand tightened the screw back in from the back side of the unit using the extension and joint.
wire harness in the back of refrigerator at the compressor was cut
and the capacitor was missing along with the power cord . I ordered a new harness which included the power cord I was very easy to install everything plugged right in and I installed a new capacitor and refrigerator works great
Changed only the capacitor at first. After a day or so it started clicking again, only occasionally. I ended up replacing the relay also. Should have replaced them both the first time I had removed them. I followed the instructions in the video, which were excellent and easy to understand.
0 of 1 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Model Compatibility
This part works with the following models:
Fix Number: FIX11743364
Manufacturer Part Number: WP65889-4
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
