This part is used as a safety feature. If your range overheats this part will shut the range down.
Works with the following brands:
Whirlpool, Maytag, KitchenAid, Kenmore
Works with the following products:
Range, Microwave Oven Combo
Fixes the following symptoms:
Little to no heat when baking, Oven is too hot, Element will not heat, Little to no heat when broiling
Part# WP3196548 replaces these:
AP6007866, 313214, 3147620, 3196548
Videos For installing this part.
Replacing your Safety Thermostat
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched. Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Phil
October 1, 2021
range will not turn on. Is there a fuse on this model. Range was turned off at the breaker manually because of power surges and low voltage
For model number acr4503SFW3
Hello Phil, Thank you for your inquiry. We have researched the model number you have provided, and the safety thermostat acts like a thermal fuse and will cause the stove to shut down if it overheats. We also recommend checking the terminal block, the oven sensor and the wiring. You can test the parts with a multimeter. If you are unfamiliar with how a multimeter functions, we have videos available to assist you. Check the wiring for any visible damage. Good luck with your repair.
How do you test the safety thermostat to see if it is functioning for the oven? what ohm reading?
For model number ymer8700ds1
Hello Daryl, thank you for reaching out. Testing the safety thermostat, part number FIX11740991 is an easy job. With the sensor at room temperature, measure the resistance between the two prongs at the end of the sensor connector. The resistance of the sensor should read approximately 1080–1090 ohms at room temperature. We hope this helps!
Was this helpful?
Thank you for voting!
Related Parts Additional or alternate parts to consider.
This genuine OEM part is a replacement sensor for your oven. The sensor works with the control board to measure and regulate the temperature in your oven. If the sensor has become defective, the temperature in the oven c...
Installation Instructions Provided by Fix customers like you.
Average Repair Rating: 5.0 / 5.0, 1 reviews.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
remove back panel , remove thermostat where the blue and red wire join together . blue (broil) red (bake) . The thermostat burned out because of a bad electronic board that was caused when using the self clean. i also replace the board with a refurbished board and the range is working like new. won't use self clean again, it gets too hot.
3 of 4 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Model Compatibility
This part works with the following models:
Fix Number: FIX11740991
Manufacturer Part Number: WP3196548
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
