Detergent Dispenser

I turned the dishwasher breaker off and turned off the water supply in case I had to move the dishwasher out to remove the door cover. I removed the screws with a star tip screwdriver on the inside cover of the door. Since I was able to remove the dispenser without completely removing the cover, I didn't have to move the dishwasher out ... Read more further. (I had about four inches of room to remove the dispenser). I had to pry the metal flanges on the door cover out a little that were surrounding the dispenser's bottom to bypass the small plastic edges holding the dispenser tight against the door cover. I removed the small wiring connector by pressing the small plastic retainer and pulled out the connector. I had a little bit of trouble removing the two plastic fastener clips holding the wiring to a bracket. I used a needle nosed plier to close the upper plastic tines to pull the clips through the holes. After I removed the old dispenser, I bent the metal flanges on the door cover back in. I pushed the new dispenser into the door cover and made sure I heard the the sound of the metal flanges clip onto the plastic lips of the dispenser. I turned the water and power back on and tested the operation of the new dispenser. The dispenser worked properly.