Knob, Gray

I started with a pair of channel locks turn the knob do in the position where I thought it should be then I took a little screwdriver and spread that little clip so I could remove it and then installed the new one with the new knob on it turned it to a setting hit the start button and I'm at work just like it was supposed to thank you for ... Read more your speedy delivery and help me get to the destination I was trying to achieve again thank you very much for your help

Remove the dryer cord or shut off breaker, then take off all of the knobs from the appliance front, remove the six screws from the back, lift up keeper in lower right corner and twist out of place, move wires from old to the new timer, push thru hole in appliance front and twist into place. Replace the six screws, knobs, turn breaker bac ... Read more k on or put cord back into place, test timer operation, and I was done in 15-20 minutes.

Put new know on d-shaped shaft

Easy job, but take your time and work carefully. Twist the old timer off keeping the wire connections. Twist on the new timer and transfer the wires one at a time. Wires are on tight so you might need pliers.

Open the box for the replacement part and plugged wire for wire and closed the cover back on and plugged into dryer outlet and it worked great

First unplug power cord. I removed three Philips screws at top rear of control panel and tilted it forward. Then facing front of machine slide panel to the right to free bottom tabs. Twist out timer switch counter clockwise by releasing the locking tab.Install new timer switch by rotating it clockwise. Then careful remove wires one at ... Read more a time from old timer to new installed timer. I used a small screw driver to pry up wire connectors. Its much easier to swap wires one at a time so as not to get confused about location positioning. Then with all wires firmly in place place control panel bottom back into slots tilt in place reinstall three screws, plug power cord back in.JOB DONE

I'm probably average to slightly below average on the handyman scale so trying to switch out an electrical part on an appliance was a definite don't mess with, but reading a few other post convinced me to give it a try. It was as easy as everyone says, few screws in the back to get to the timer, unplugged the wires 1 at a time and plugged ... Read more them into the new one so I wouldn't get mixed up. Screwed the back back on and dryer is like new. Thanks ! Matt

I simply put the new knob on and instantly I could select my dryer heat and the dryer ran fine. I also had delivery within 24 hours. Thanks.

old knobs were cracked just pulled them off and installed the new ones....

Replaced broken knob by pulling old one off and putting new one on.