HOSE ASSEMBLY, DRAIN

Disconnect washer, pull out and remove the left side panel. Undo the twist ties holding the drain hose in position. Set the washer on it's right side Remove the two screws holding the bottom metal panel. Undo the clamp which holds the hose onto the pump. There is a white plastic insert around the hose that secures it to the washer frame where the hose exits the washer. This can be removed by pinching the two arms of the insert to remove it from the hose and the washer frame. You can now remove the hose. Reverse the process for installation. The procedure is quite easy.

I shut off the water supply and the power. removed lower panel and disconnected the electrical and water supply. Unscrewed under counter support brackets and pulled dishwasher out from counter. Tipped unit on right side (placed on foam pad) unscrewed bottom panel and left side panel. detached old hose from pump with adjustable pliers and removed hose bracket from back panel just squeeze ends together and it comes out. Attached new hose to pump with squeeze fitting and had to plug short black hose that came with the new hose that would not fit anywhere on my unit (must be for newer models). Then just reconnected everything in reverse and pushed unit back under counter and reconnected water and electrical. Then connected the new drain hose to the drain with ring clamp (not supplied) and turn the water and electricity back on and ran a test load (all was good). reinstalled the bottom panel.