The genuine OEM replacement rack stop clip is for dishwashers. It measures just over an inch and is made of gray plastic. The purpose of this part is to prevent your dishwasher rack from pulling out too far and falling out of the dishwasher. If you have difficulties closing your door, your rack continuously falling off, or a door latch failure, you may need to replace this part. They are sold individually and can be used on the right or left side of the upper dish rack. It is recommended to replace both sides at the same time, meaning you will need to order 2 of this part. For this easy repair, start by pulling out the rack, then use your screwdriver to reach behind the rack stops and push on the clips. This should allow you to remove the stops from the track. Next, slide the track back over the rollers and snap the new track stop in place.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
