Have you ever purchased from us before?
Thank you for helping make our site better.
Manufacturer #: WD12X10327 /
Manufactured by: GE /
Fix #: FIX3486910
Manufacturer #: WD12X10327 |
Manufactured by: GE |
Fix #: FIX3486910
I bought these parts for my girlfriend, had them sent to her house, and before I could get there to help her fix the dishwasher, she had done it herself! She reported that it was straightforward and was not nearly as difficult as she dreaded it would be. I think her comment was, 'I should have done this a LONG time ago vs just putting up with it being broken!' Don't be afraid to dig in there and do it yourself; you'll be amazed at the self-confidence and sense of satisfaction you get from the repair.
Were these instructions helpful?
I used the flat screwdriver to pry the end cap (2) from each of the slide rail's. Then pulled the rack out and removed all 4 of the roller and Axle. To remove them, they just are clipped onto the rack so just in clip them. You might want to use the screwdriver. Snap the new ones into place and slide the rack back in the rail's and put the end caps back on. Job complete.
The rollers roll inside of a 'C' shaped channel that is capped on both ends with a plastic insert. The most confusing problem was how to get the plastic inserts out without breaking them. The trick to removing the end cap on each side is to pry the rear tab on the cap backwards until it clears the C channel then it can easily be moved outside of the channel and the end cap comes out easily. After both end caps are removed the entire top rack slides out and the new rollers can be easily snapped in place. Once you know the trick about the end caps, they can be easily popped back in place to secure the top rack again.
You have the best repair-parts site on the web. Easy to navigate and purchase, the parts arrived on time and the instructions were clear and accurate. Nice!
Super easy to change just remove old part (made of plastic) with pliers and simply snap on new parts could not be any more simple
I pryed out the end caps and pulled out the old wheels and snapped on the new ones slid it back in and capped them off ... Be careful not to pop the end caps off. Luckily they are flexible and bend easily . I'm glad it worked relatively easy !!.... thank for fast delivery !!!
remove end caps remove upper rack remove roller assemblies and replace with new ones install rack and replace end caps. note buy new end caps at the same time they are cheap and make the job easier
Removed the side track keeper wheels and rack rail. Removed end stopper in rack rail ends. Replaced all four rollers and axels. NOTE: The removal of the track end piece was tricky but by turning the keeper CCW the stopper came right out and I was able to replace the old wheels and then reassemble the racks and axels. Piece of cake.
removed upper basket from dishwasher. remove old roller and axles (4). These slip off of basket. Mine were brittle and actually broke off. Slip new rollers in place; install basket. To remove basket you need to remove clips from front channels. Pull inside flap down and it will come out; reverse process to install.
Watch the video for the repair. Even for a novice like me,the repair was very easy. With new parts,older machine works like new.
One-third of the produce grown globally is wasted due to throwing…