Have you ever purchased from us before?
Thank you for helping make our site better.
Manufacturer #: 809006501 /
Manufactured by: Frigidaire /
Fix #: FIX9495545
Manufacturer #: 809006501 |
Manufactured by: Frigidaire |
Fix #: FIX9495545
Watched the video, easy replacement.
Were these instructions helpful?
Opened plastic package with scissors. Opened door of dish washer. At bottom of door pulled gripped old gasket seal with plyers and pulled it out of slot. Pushed new gasket in place...too long. Marked extra length with sharpy black pen and removed gasket. Cut gasket with scissors and pushed it into slot. Fit perfect. Note slot us under lip of door, a little tricky to find in order to install. Works great, no more leak.Make sure you use a screw driver on the door screws to make sure they are all tight. Too seal them use Blue Lock tight sealer.
The old gasket was easy to pull out. I didn't get the new one in straight the first time and closing the door was difficult. The new gasket popped out and I got it lined up better and pushed it back in. Tested the seal by running the rinse cycle and no leaking!
As instructed in the video from your website. Very easy.
I watched the video that you provided and I proceeded to follow the directions and install the gasket. Very easy once my husband stopped interfering.However , the bad news was that the leak was not fixed. There is a much bigger leak that seems to spray water from somewhere on the bottom, towards the center/rear of the machine. I can't get a handle on the exact part without pulling the entire machine out, which is complicated because of the manner in which it was installed. So, if I decide to take it on, I will most definitely be calling upon your fantastic customer service. Thank you. Sincerely, Noreen
I installed a new gasket on door bottom.
Hi there, so I removed the old plastic strip and noticed that some of the edges were dry rotted off. I installed the new one, however, be sure to line it up correctly so that it seals the entire bottom of the door. Sadly, this helped, but the actual problem is the spray arm. It came undone from the unit and melted a hold on the side of the arm, which in turn causes water to go everywhere-in large quantities'. I'm ordering that part next, wish me well!
Followed the video on howvto do it... Got the tools needed. Took no time at all! Very happy with the results!
Replaced tub gasket and door seal just like the video shows. Was very easy.
Garden plants are perfect for coloring scarves, play silks, shirt…