General Electric Washer Dryer Combo Drums and Tubs

★★★★★

★★★★★

2 Reviews

Fix Number

FIX6447706

Manufacturer Part Number

WE1M1067

This single drum bearing slide is an OEM approved replacement part for dryers. It can also be known as a bearing drum slide, pad, or glide. The slides attach to the inner most slots on the front bearing. As the dryer rotates, the drum bearing slides help to support the front of the drum. If your appliance becomes noisy, is not drying properly, or leaves marks on clothes, it may be time to replace it. If you are replacing one slide, we recommend replacing the other slide at the same time, as they deteriorate at a similar rate. You will need to order 2 of these parts as there are 2 in each dryer. It is approximately 2.6-inches deep, 0.06-inches in height, and 0.5-inches wide. This part is denoted as being green in the title, however users and technicians have noted it is actually gray in color.

★★★★★

★★★★★

1 Review

Fix Number

FIX755842

Manufacturer Part Number

WE1M504

This single drum bearing slide attaches to the outer-most side of the bearing. This part is also sometimes referred to as a drum slide, drum glide, or drum pad. It provides support to the front of the drum as it rotates. They are approximately 3-inches long, 1 inch wide and made from a durable white plastic. If your appliance starts making unusual sounds, is not drying clothes properly, or leaves marks on clothes, it may be time to replace this part. The dryer has 2 slides, which we recommend replacing at the same time, as they tend to wear out at the same rate. You will need to order 2 of this part to replace both drum bearing slides, since it is sold individually. Before you begin this repair, be sure to disconnect the power to the dryer.

★★★★★

★★★★★

2 Reviews

Fix Number

FIX960316

Manufacturer Part Number

WE3M26

Located on the inside of the dryer front panel, the front drum bearing helps your appliance to operate as quietly as possible. It allows the front of the drum to glide smoothly on the felt seal of the front panel when the drum is rotating. This manufacturer-approved part is made of a durable white plastic and measures approximately 9 inches by 20 inches. If your dryer makes a continuous banging noise while it is powered on, it is likely that the drum bearings need to be replaced. Keep in mind that the drum slides should be replaced at the same and will need to be purchased separately (the front drum bearing holds 4 glides), as this part includes the bearing only.

Fix Number

FIX755802

Manufacturer Part Number

WE03X10007

Sold individually. There are some dryers that require 2 per dryer. They attach to the outer-most sides of the bearing.

Fix Number

FIX264864

Manufacturer Part Number

WE03X10001

This top drum glide kit comes with the adhesive.

Fix Number

FIX1482128

Manufacturer Part Number

WE14M119

Fix Number

FIX10055836

Manufacturer Part Number

WH45X10149

The outer tub assembly houses the spin basket and holds water during the wash cycle

Fix Number

FIX3501469

Manufacturer Part Number

WH45X10106

Fix Number

FIX11763318

Manufacturer Part Number

WH45X25257

Fix Number

FIX267868

Manufacturer Part Number

WE3X78