PNRQ15RBL00 General Electric Water Filter System - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Conrad from GLENDALE, AZ
- Parts Used:
- WS21X10019
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Plastic battery tray broke from being removed and reinstalled over the past 8 yrs.
Took the new tray from the package, put a new battery in it and slid the new tray & battery into the base of the RO faucet. No problem, just as it should have been, except the new tray should have come with a new rubber washer.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Erik from LAS VEGAS, NV
- Parts Used:
- WS10X10045
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
Reverse Osmosis faucet leaking beneath sink.
Closed all water valves, then drained residual water. Removed In-Sinkerator in order to have room to manipulate faucet attaching hardware. Removed old faucet. Ensured two water drain lines and one R/O water supply line were run up through hole in sink. Placed sink gasket over all three lines. Attached smallest drain tube to the faucet base first, followed by larger drain tube, then supply tube. Opened water valves to ensure no leaks before starting installation of mounting hardware. Mounted faucet base over hole in sink and placed long securing bolt through faucet locator. Had an assistant hold the wing nut clamp on the underside of the sink while I tightened the bolt from the top. Once the faucet base was tight and secure, I re-used the ring gasket from the old base and mounted the faucet onto the base. In the case of my GE unit, it had alignment keyways that allowed the faucet to drop in and then lock in place when rotated 45 degrees counterclockwise. After ensuring faucet top and base were lined up and locked together I installed the set screw in the back of the faucet to complete the install.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- H. P from DEL RIO, TX
- Parts Used:
- WS32X10021
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Wrench (Adjustable)
Bottom Rusted Out
Remove filler hose from old tank replace with new tank and hook up fill hose
Was this instruction helpful to you?
Thank you for voting!
Filters needed replaced
drained the system and depressurized the system. Removed the filter unit from the wall and removed the filters. Replaced the flow restrictor and re-installed the filters. Hung the filter unit and recharged the system
Was this instruction helpful to you?
Thank you for voting!