Models
>
113177060
113177060 Craftsman Utility Vacuum
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for 113177060
Viewing 4 of 4Keep searches simple, eg. "belt" or "pump".
This is a genuine Craftsman replacement part. This red stripe vacuum replacement filter fits all current craftsman vacuums that are 5 gallons or more. This filter easily picks up sawdust, wood chips, ...
No Longer Available
This is an authentic OEM Craftsman replacement part. This vacuum filter plate is located at the bottom of the filter cage; it helps provide support for the filter. The filter plate is made out of the ...
No Longer Available
This is a genuine Craftsman replacement part. This hose combo is an attachment that can be used with a vacuum, and auger or a table saw. It helps you keep your project and your work space free of debr...
No Longer Available
This is a genuine Craftsman replacement part. This nut is a commonly used in wet/dry vacuums, without this nut your vacuum will not run efficiently, or it might not run at all. The filter nut helps pr...
No Longer Available
Special Order
This is a genuine Craftsman replacement part. This wet/dry vacuum extension wand fits tightly on any 2-1/2 inch hose to give you better reach as you clean. The 20.5-inch wand extension is made out of ...
No Longer Available
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Gary from WILLMAR, MN
- Parts Used:
- 16928
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- 30 - 60 mins
The hose was broken - separated from the connector
I was disappointed to find the hose kit to not be correct, since the information on the site said it would work for my model. After trying various combinations of ends I decided to modify my existing connector. It had a ridge that would not let the hose coupler go on. I was able to grind that ridge off. I then fitted the connector over th
... Read more
e end, after putting waterproof adhesive on the end. I let that set up for 4 hours, then inserted the hose inside the other end. So far it is holding.
Read less
Was this instruction helpful to you?
Thank you for voting!