RF28HMEDBSR ((AA-05)) Samsung Refrigerator

This is the Samsung French door refrigerator style that so many people have complained about freezing up and not cooling the top section. I first changed out the defrost thermostat and this did not correct the problem. I done a quick resistance check on the temp sensor that's mounted on the evaporator itself. The resistance would change when holding an ice cube on the sensor so I just assumed it was ok. PLEASE TAKE NOTE: When performing a resistance check on this sensor, make sure your readings match the Samsung temp/resistance chart in their literature. My sensor was way off calibration and was causing the freeze up. Its working as designed now and DW is happy again. Learn from my mistake.

unlock filter with pliers with a turn to the right, pull out and replace filter, Turner new filter to the left until it click in.

1) Remove items from freezer.
2) Remove/lift out top slider drawer, and the in door slot tray.
3) Remove lower, large plastic tub/drawer bottom.
4) Remove 6 of the 8 phillips head screws that hold the sliders to the drawer front.
5) Remove while holding up the drawer front with foot, or other spacer to hold up the drawer front when removing the last 2 screws.
6) Pull rubber gasket out of the original drawer front, and press it into the new drawer front.
7) loosen the allen screw from the bottom right side of the handle.
8) slide the handle to the right to remove it from the old door.
9) Slide the handle in place onto the new door, and tighten the allen screw on the bottom right.
10) Place the new drawer front onto the slides. (There are 2 dowel type knobs that locate the drawer front correctly.)
11) Start 1 screw into each slider, making sure that the dowels line up with the holes in the sliders.
12) Install the remaining 6 screws holding the sliders to the drawer front. 13) replace the bottom tub, the slide drawer, and long slot tray.
You're done, other than reloading your frozen items back in the freezer.