Models > PRD486GDHU

PRD486GDHU ((14)) Thermador Range

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
$11.82
In Stock
On Order
CAP
$57.07
In Stock
$6.09
In Stock
$20.12
Special Order
$5.50
In Stock
In Stock
$4.89
In Stock
$61.99
In Stock
$192.50
In Stock
In Stock
$91.62
In Stock

Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Robert from GREENWOOD VLG, CO
Parts Used:
00629722
Difficulty Level:
A Bit Difficult
Total Repair Time:
More than 2 hours
Tools:
Nutdriver, Socket set
Four extra Low burner igniters malfunctioned, Sparking when burner off.
The sole review for this part by Andrew was most helpful and accurate with one exception: he said that there were two nuts Which needed to be removed in order to pull off the front knob panel. There were actually two on each end for a total of four, which confused me, as I wondered if I had the right ones. Another thing that would be help ful for somebody considering doing this repair is to know that it takes a deep quarter inch socket With two 6 inch extensions to reach these nuts through holes in the interior side panels. Also, take a look at the replacement potentiometers, and you’ll see that there’s a slot that can be lined up so that they can be pulled off the side of the shaft rather than off the front of the shaft. This repair took me about six hours. I’m mechanically inclined and work methodically, but since I’ve never done this repair before it was quite time-consuming.
5 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!