Models
>
WE13T38D
WE13T38D (2001) Husqvarna Lawn Tractor
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for WE13T38D
Viewing 10 of 10_WW_1.gif "Page A Diagram and Parts List for 2001 Husqvarna Lawn Tractor")
_WW_2.gif "Page B Diagram and Parts List for 2001 Husqvarna Lawn Tractor")
_WW_3.gif "Page C Diagram and Parts List for 2001 Husqvarna Lawn Tractor")
_WW_4.gif "Page D Diagram and Parts List for 2001 Husqvarna Lawn Tractor")
_WW_5.gif "Page E Diagram and Parts List for 2001 Husqvarna Lawn Tractor")
_WW_6.gif "Page F Diagram and Parts List for 2001 Husqvarna Lawn Tractor")
_WW_7.gif "Page G Diagram and Parts List for 2001 Husqvarna Lawn Tractor")
_WW_8.gif "Page H Diagram and Parts List for 2001 Husqvarna Lawn Tractor")
_WW_9.gif "Page I Diagram and Parts List for 2001 Husqvarna Lawn Tractor")
_WW_10.gif "Page J Diagram and Parts List for 2001 Husqvarna Lawn Tractor")
Keep searches simple, eg. "belt" or "pump".
$6.09
This is a premium-quality OEM front wheel flange bearing (sometimes called bushing) commonly used in riding lawn mowers. They are used to keep the wheel held in place securely. It is sold individually...
In Stock
This manufacturer-approved ring clip is found in various lawn and garden equipment models. A ring clip is used as a fastener that secures components or assemblies onto a shaft or housing (such as part...
In Stock
This is a flat metal washer found in various models of lawn mowers and is sold individually. This flat washer can have various functions depending on the equipment; however, its general purpose is to ...
In Stock
This is an OEM axle cap for lawn tractors and is sold individually. It stops debris from getting into the wheel hub and axle. This axle cap is prone to wear and tear and should be replaced when it is ...
In Stock
$4.88
This is a genuine hex flange locknut for a lawn mower. It attaches to the carriage bolt (sold separately), fastening the axle assembly braces in place. This part is sold individually, however most mod...
In Stock
$3.65
This is an OEM lawn mower deck mandrel spacer washer, sold individually. It measures approximately 43/64-Inches in diameter, 1-1/8-Inches outer diameter, and 5/32-Inches thick (these measurements are ...
In Stock
In Stock
In Stock
In Stock
This part includes one genuinely sourced washer for a ride-on lawn mower. Washers help to disperse the load and provides a tight seal in between components. Depending on your unit, the applications wi...
In Stock
In Stock
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Wheel bushings were bad
Removed old clip removed rim from tractor, removed grease fitting on rim, took hammer and screw driver knocked out old bushing turned rim over knocked out other bushing. Press in new bushings reinstalled grease fitting slide tire back on tractor, put retaining washers on then locking clip put on dust cover grease at grease fitting. Repeat
... Read more
other side.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gary from PILESGROVE, NJ
- Parts Used:
- 532123583
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Take the wheel off. Place the key in the slot. Put the wheel back on.
Just described it.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Frederick from BINGHAMTON, NY
- Parts Used:
- 532121749
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Front wheels, too much end play
Shimmed the wheels out on axle.. No more slop.
Was this instruction helpful to you?
Thank you for voting!