TB230 (12AVB26M066 2010) Troy-Bilt Lawn Mower - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- MICHAEL from Kennewick, WA
- Parts Used:
- 734-04018C
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
The treads on the front drive wheels were worn down to the point that they provided little traction.
Removed a single nut on each end of the drive shaft with the appropriate socket. Wheels then slipped off. Cleaned/polished the shaft with fine sandpaper, lubed with silicone spray, slid on the wheels and reinstalled the nuts with the same socket. Wheels were an exact fit and OEM quality. Done in 15 minutes start to finish.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ronald from WAYNE, MI
- Parts Used:
- 734-04018C
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
Front drive wheels were wore out
Unbolted old wheels and bolted new wheels to my lawn mower
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jay from GERRY, NY
- Parts Used:
- 734-04018C
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
Not the exact fit
I had to drill and tap the ends of the axle and put a 1/4” bolt in to fasten the wheels. The hubs were not the same. They fastened differently.
Was this instruction helpful to you?
Thank you for voting!