135202 ((0284-01)) Briggs and Stratton Engine - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Thomas from ALFRED, ME
- Parts Used:
- 397358
- Difficulty Level:
- Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Pliers
5 HP Briggs and Stratton chipper shredder - no spark
Removed old sparkless magneto, replaced with new part PS9278124 Magneto, and still no spark. The only conclusion that I can draw, is this magneto is defective,
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dennis from MUKWONAGO, WI
- Parts Used:
- 272538S
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver
no gas to carb
pulled off fuel pump cover ,cleaned surfaces. Applied gasket sealer and replaced fuel pump diaphragm.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bruce from CARNATION, WA
- Parts Used:
- 691656
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
Wouldn’t start.
I installed a new solenoid starter. Took me a total of 20 minutes. Started right up.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Steven C from CENTREVILLE, MI
- Parts Used:
- 495606
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
Old diaphragm dried up
Tore carburetor off leaf blower and replaced. To do that require taking off the air cleaner removing the gas tank and all the brackets holding the controls on it. And keeping track of all the screws and Wires that control choke and throttle. I took several photographs. I did not need all the gaskets and jet’s that were included in the kit but it had what I needed.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Alberto from PALMETTO BAY, FL
- Parts Used:
- 692237
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Socket set
Generator would not start, Birggs & Stratton recommended to replase Gasket Exhaust.
Remove the spark suppresser, 4 face screws, 2 bottom screws and the two screws the hold the gasket. I also had to back out the top screw of the cover it blocked and prevented the removal of the gasket.
Was this instruction helpful to you?
Thank you for voting!