Models > 325EX

325EX ((1999-10)) Husqvarna Edger

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
$10.76
Located inside the fuel tank, the fuel filter removes debris before it can reach the carburetor. If your small engine starts with difficulty or idles rough, it may be clogged, restricting the flow of ...
In Stock
$5.09
This is a hose for your lawn and garden equipment. It is just over 4 inches long, and made of a strong, and durable plastic. The hose is connected to the air purge bulb and the carburetor, and may be ...
Special Order
This is a hex nut flange for your lawn and garden tools. It is size M8, meaning it has an 8mm inner diameter, and a 1.25 thread pitch. The hex nut has a washer like base to ensure the nut stays tight....
In Stock
Special Order
$37.10
In Stock
$5.97
In Stock
In Stock
$3.81
In Stock
$8.37
In Stock
In Stock
$8.91
In Stock
$5.97
Special Order

Questions and Answers

Be the first to ask our experts a question about this part!

Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
  • Customer:
    Jeremy from DILLSBURG, PA
  • Parts Used:
    537034101
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
Fixed up somebody's old trimmer they threw at the curb
This trimmer was in relatively good shape. Somebody had thrown it out! They thought they had broke the rewind, but when I ended up taking it off, it sucked right back in. They also must have broke the vibration plate on the bottom. With the screws and plate I bought from here, plus a new head and service kit I got elsewhere , this thing ran like a champion again.
3 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • Customer:
    Bruce from ALGOMA, WI
  • Parts Used:
    503718201
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
part not same
Ordered on/off switch. My switch had only one wire terminal. Replacement had two. I ran a wire from one to a screw as a ground. Switch worked fine.
2 of 8 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!