Models > SHE3AR75UC

SHE3AR75UC ((23)) Bosch Dishwasher

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
The pump ejects the water from the dishwasher through the drain hose.
In Stock
This circulation pump with heater is for dishwashers. Circulation pump with heater moves heated water through the spray arm to clean the dishes. Unplug the dishwasher before installing this part...
In Stock
$30.43
In Stock
This door cable is for dishwashers. Door cable helps balance and support the weight of the door as it opens and closes.
In Stock
In Stock
$33.16
In Stock
$35.23
In Stock
$63.49
In Stock
$81.48
In Stock
$24.86
In Stock

Questions and Answers

Be the first to ask our experts a question about this part!

Common Problems and Symptoms for SHE3AR75UC

Viewing 10 of 10
Leaking
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Not draining
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Not cleaning dishes properly
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Not drying dishes properly
Fixed by these parts
Fixing
How to fix it
Will not fill with water
Fixed by these parts
Fixing Fixing
How to fix it
Door latch failure
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Noisy
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Will Not Start
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Will not dispense detergent
Fixed by these parts
Fixing
How to fix it
Door won’t close
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Bill from NORTH HALEDON, NJ
Parts Used:
00622058
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers, Wrench set
The valve allowed water to fill the dishwasher when not in use.
This was the third time I replaced a fill valve in a Bosch diswasher, twice in this unit and once in a previous unit. I read the installation hints on your web site and want to add the following suggestion.

The notes on your web site say you can remove the valve from behind the toe face and pull it out to reach the hose and plu g. I found that the Bosch designers called for both the hose and wire to on the short side. I found that pulling the dishwasher forward 6" to 9" allows you to access these connections from the side at least to hold them while making the connection. I hope this helps. Thank you, Bill
5 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Terry from BIRMINGHAM, AL
Parts Used:
00622058
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
Drain Pump runs continuously - inlet valve leaking into bottom tray
disconnected inlet hose and water line from sink, removed old inlet valve and installed new valve and reconnected inlet hose and water line from sink - checked for leaks.
6 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
TONY from PALMDALE, CA
Parts Used:
00622058
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers, Wrench (Adjustable)
No water in machine, can not wash dishes.
Turn off water, disconnect power cord, remove front kickplate. Remove 2 screws that hold the water inlet valve, pull it out, disconnect electrical connection, disconnect water supply.. Check the inlet valve with volt-ohm meter for continuity. If it is good, then the valve is stuck shut. The ohm reading should be in the 900-1100 range. Rep lace valve, installation is the reverse.
4 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!