Models > EA-410

EA-410 (EU S05636001001 - S05636999999) Echo Auger

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for EA-410

Viewing 14 of 14
Keep searches simple, eg. "belt" or "pump".
This check valve or the fuel tank vent is connected to the fuel tank in the following products: hedge trimmer, leaf blower/vacuum, chainsaw, edger, engine, tiler, auger, water pump, chipper shredder, ...
In Stock
This is an OEM fuel filter and is sold individually. This repair is very easy and will only take a few minutes. It is also a very important maintenance task that should be done regularly. This part is...
In Stock
In Stock
$4.99
This is a clip for a variety of lawn and garden equipment. The clip is made of a durable metal, and is 6.5mm in diameter. This part is most commonly used to clamp tubes and hoses in place. The clip is sold individually.
In Stock
$4.99
This nut is used for a variety of handheld gardening tools. The nut has multiple applications depending on the tool you are using. Refer to the diagram provided by the manufacturer for installation in...
In Stock
In Stock
In Stock
$3.99
In Stock
In Stock
In Stock
In Stock
In Stock

Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Keith from NORWOOD, NJ
Parts Used:
A369000460
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Replace clogged fuel filter.
Thru fuel cap, insert copper wire with hook formed on end. Fish around until you grab the fuel line. Pull the fuel line and filter thru the fuel fill neck.
Pull off old filter and replace with new. Push back into fuel tank & be done.
19 of 30 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Richard from SPRING HILL, FL
Parts Used:
12318139130
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
Bulb was worn out and broken open
The unit is a press fit. To remove the old one required breaking the plastic compression tabs that hold it in place. That was simple enough. Replacing requires lining up in the correct position to meet the inner hose. Then push it in. The compression tabs on the replacement click in and hold.in place.
6 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!